Stacey Jambura: The Adventure Begins, July 8, 2012

Stacey Jambura
July 6 – 17, 2012
.
Geographical Area of Cruise: Gulf of Mexico
(You can also view the NOAA ShipTracker here: http://shiptracker.noaa.gov/shiptracker.html)
Date: July 8, 2012

.

Weather Details from Bridge: (at 18:45 GMT)
Air Temperature: 29.50 ◦C
Water Temperature: 30.70 ◦C
Relative Humidity: 66%
Wind Speed: 1.52 kts
Barometric Pressure: 1,017.82 mb
.

Science and Technology Log

Virtual Tour of the Oregon II

I know many of you may have never been on a ship before and are probably curious to know what it is like to be aboard the Oregon II. I’m going to take you on a little virtual tour, but first you will need to know some common terms that are used to refer to certain areas on the ship.

Ship Term

What It Means

Bow The front of the ship.
Stern The back of the ship.
Starboard The right side of the ship when facing the bow.
Port The left side of the ship when facing the bow.
Forward The direction towards the bow of the ship.
Aft The direction towards the stern of the ship.
Bridge The location of the command center for the ship.
Galley The kitchen.
Mess Hall The dining area.
Head The bathroom.
Stateroom Where crew members sleep.

On Deck

The Bow

At the bow of the ship is where most of the scientific collection equipment is deployed/released. The CTD (conductivity, temperature, depth), the neuston net, and the bongo nets. (I will talk about each one of these in upcoming blogs.) There are several large cranes that help lift these up off the deck and swing them over the edge of the ship to be released into the water. When you are at the bow and the cranes are running, it is very important to keep yourself safe. Everyone who is at the bow when the cranes are operating is required to wear a hard hat and a PFD (personal floatation device). You never know if a cable will snap or the wind will swing the equipment towards you. There is a sensor on the PFD that is activated when large amounts of saltwater touches it, like if you were to fall overboard. Once salt water touches the sensor, the PFD will inflate and keep you afloat until you can be rescued.

Oregon II Bow
Oregon II Bow

The Stern

At the stern is where the samples from the neuston cod end and the bongo cod ends are collected and preserved in jars for scientists to examine at a lab. This is also where the large trawling net is deployed. The scientists spend most of their time at this part of the ship.

Stern of the Oregon II
Stern of the Oregon II

What Makes the Ship Sail?

Bridge

The bridge is where the officers of the Oregon II work. It is located toward the bow of the ship. The bridge has all of the navigation tools necessary to steer the ship to the next sampling station. There is also a lot of weather equipment that is monitored and recorded throughout the day. The bridge is where you’ll find the best views of the ocean because it is almost completely surrounded by windows and it’s higher than any other room on the ship.

At the Helm
At the Helm
Bridge
Bridge

.

Chart Room

This room is where all of the maps are stored. While there are more technologically advanced methods used for navigation on the ship located in the bridge, it is important to have physical maps on hand to refer to, especially if the instruments stop working for any reason.

Chart Room
Chart Room

Engine Room

Before we untied our ship from the dock I received a full tour of the engine room. This is where the heart of the ship is. Everything in the engine room powers the ship. Our water is even purified down here using reverse osmosis (passing water through a membrane to filter the water). Because of this machine, we can filter salt water into fresh water to use on the ship.

Reverse Osmosis
Reverse Osmosis Machine

It was great to venture down to the engine room  before we set sail because I was told that it can get up to 110 degrees when the engines are running! It is a large space, but it feels small because of the large equipment. There are two of everything, which is especially important if something needs repair. Below is a picture of the two engines. The other is a picture of one of the generators.

Engine
Engine
Generator
Generator

Living on a Ship
Stateroom

My stateroom is compact, but its main purpose is for sleeping so size isn’t really an issue. There is a bunk bed, a sink with a mirror, latching drawers for clothes, and a hide-away desk. There is also a compact tv that is attached to the bottom of the top bunk and folds up when it is not in use. I only use the room to sleep and get ready for my shift because my bunkmate works the opposite watch shift as mine (midnight to noon), and I want to be the least disruptive as possible. After 12 hours shifts, sleep is really needed and helps reenergize you in time for the next watch.

Stateroom Bunks
Stateroom Bunks
Stateroom
Stateroom

The Head

The head is the same as a bathroom. On the Oregon II there are private and communal heads. The private heads are for the officers and are typically connected to their staterooms. The communal heads are open for any crew member to use. There are also communal showers for the crew to use. All of the toilets use salt water that is pumped onboard. The reason fresh water is not used is because it is a precious source on the ship and is not readily available from the ship’s surroundings. The sinks, showers, drinking fountains, and ice machines all use fresh water. Fresh water on the ship should never be wasted. Water for the sinks is timed so that there will never be a faucet that is accidentally left on. Showers are to be kept to a maximum of 10 minutes, though it is encouraged that they be even shorter.

Heads
Heads
Shower
Shower

Galley and Mess Hall

This is one of my favorite places. The galley is where our ship’s cooks prepare all of the wonderful food for the crew. The mess hall is where we all eat during meal times. During meal times it can be quite crowded in the mess hall as there are only 12 available seats and over 30 crew members onboard who are ready to eat. There is an “eat it and beat it” policy to help ensure that everyone who comes down to eat will be able to find a spot. Despite this, it is still a great way to converse with the crew and talk about events from the day before giving up your set to another hungry crew member.

Galley
Galley
Mess Hall
Mess Hall

Crew Lounge

This is the place where crew members who have some down time can gather and socialize, though down time can be rare. There is satellite tv, a couple of computers, and hundreds of movies to choose from. Some available movies haven’t even been released onto DVD for the common household yet, but they are available to the military. They do this because not everyone has access to current movies when they are away from home for extended periods of time. All of the DVDs are encrypted and can ONLY work on the machines aboard the ship. I was excited to find a copy of The Hunger Games and I plan on trying to watch it before my trip is over.

Lounge 1
Lounge 1
Lounge 2
Lounge 2

Labs on the Oregon II

The Wet Lab

The Wet Lab is where all of the samples from the groundfish trawls are sorted, counted, measured, weighed, and sexed (gender identified). Buckets filled with animals from the nets are dumped onto a large conveyor belt and spread out to make sorting the different species out into individual baskets easier. Everything in the wet lab can get wet except the sensors connected to the machines. We need to be cautious around the sensors when we are cleaning up after a sampling so as not to get water in them.

Wet Lab
Wet Lab

The Dry Lab

The Dry Lab is where all of the computers are located that record all of the data from the samplings. As the name of this lab states, everything in it is dry. Water should never come into contact with the equipment in here because it can seriously damage it. In between samplings, this is typically where the scientists gather to wait for arrival at the next sampling station.

Dry Lab
Dry Lab

The Chem Lab

This is where all of the plankton samples are stored. It is also where water samples taken from the CTD are tested for dissolved oxygen (DO). The CTD does have its own DO sensor, but it is always best to test something more than once to ensure you are collecting accurate data.

Chem Lab
Chem Lab
Personal Log
Day 1 – July 5th
I arrived in Gulfport/Biloxi, Mississippi late in the afternoon of July 5th. The chief scientist, Brittany Palm, met me at the airport and drove me over to the Port of Pascagoula where the Oregon II was docked. We met up with two college volunteers, Kayla and Andrew, and got a quick tour of the ship  (the air conditioning was out!) before we headed over to a wonderful local barbecue restaurant. We returned after dark and were welcomed with a fixed AC! I unpacked my belongs into my latched drawers and made up my bunk bed up so that everything would be in place when I was ready to hit the sack. It took a couple of nights for me to get use to the sounds of the ship, but now I hardly notice them.
.
Day 2 – July 6th

Oregon II and IWhen I woke up the next morning, I decided to venture out into downtown Pascagoula which was only a 5 minute walk away from the ship. It is a quaint area with little shops and restaurants. I met up with the two volunteers and we picked a business that had the best of both worlds, a restaurant and a shop, to have a wonderful breakfast. We had to be back on the ship by 12:30 for a welcome meeting, but we took some time to snap a few pictures of our floating home for the next 12 days. We were underway shortly after 2 pm (1400 hours in military time). It was fun to watch our ship depart from the dock and enjoy the light breeze. It wasn’t long until we had another meeting, this time with the deck crew. We learned about the safety rules of working on deck and discussed its importance. The rest of the afternoon was spent relaxing and getting my sea legs. The gentle rocking does require you to step carefully, especially when you have to step through the water tight doors!

Day 3 – July 7th
Our first day out at sea was slow to start. We didn’t reach our first sampling station until early in the morning on the 7th, even though we left the Oregon II’s port in Pascagoula mid-afternoon on the 6th. I was sound asleep when we arrived because my shift runs noon to midnight every day, so my first sampling experience didn’t happen until almost 24 hours after we set sail. This was nice because it gave me time to explore the ship and meet some of the crew.
.

Right after lunch I got to jump right in and help finish bagging, labeling, and cleaning up the wet lab for the team that was just finishing up their shift. After we had finished it was time to conduct my first plankton sampling.  We went out on deck at the bow of the ship to prepare the CTD (conductivity, temperature, depth) device for deployment/release. After the CTD was released and brought back on deck, we deployed the neuston net to collect species samples from that same station. (I’ll explain the importance of this type of net in a later blog.) Once the collection time was complete, the neuston net was brought back on deck where we detached the cod end and placed it into a large bucket. Cod ends are plastic cylindrical attachments with screened holes to let water run through but keep living things inside during collection. The neuston cod end’s screens have 0.947mm sized openings.  We then deployed the bongo nets to collect samples of even smaller species like plankton. (I will describe the purpose of the bongo nets in a later blog.) When the nets were brought back on deck, we detached the cod ends from the two bongo nets and placed those into buckets as well. The screens on the cod ends for the bongo net are even smaller than the neuston’s at only 0.333mm. When all of the nets were rinsed to make sure nothing was still stuck to the inside of the nets, we brought the buckets back to the stern of the ship to further rinse the samples and place them into jars for further examination by scientists.

Day 4 – July 8th
Blowfish
Holding a blowfish collected from a trawling
Today was a lot of fun because I completed my first groundfish trawl. The net for this trawl is located at the stern of the ship. When the net was brought back up on deck, it was emptied into a large box. There was quite the commotion when the fish were emptied out of the net. Not only were the fish flopping around like crazy and splattering water everywhere, their scales flew everywhere and it looked like shiny confetti! Anyone who was in a 6 foot radius was bound to be covered in scales. By the end of the day I thought I was part mermaid with the amount of scales that had stuck to me!
.
There were so many fish in one of our trawls that we had to use large shovels to place the fish into more manageable sized baskets. The baskets were brought inside the wet lab to be sorted, weighed, measured, and labeled.
.
The coolest animals I saw today were sea urchins, a sharpnose shark, and a blowfish. It was also fun to observe the different crab species, so long as I kept my fingers away from their claws!
.
Question of the Day
There is only one right answer to this question. ? You’ll be able to find it at one of the links I placed in my blog. Can you find the answer?
Good Luck!

2 Replies to “Stacey Jambura: The Adventure Begins, July 8, 2012”

  1. Wow! How cool to hold a blowfish! I’m happy to hear that you’re enjoying this amazing experience and don’t seem to mind fish scales. You always were partial to mermaids (as in Disney). Guess you got a chance to be one! Lucky you!

    Love, Mom & kitties

Leave a Reply

%d bloggers like this: